The swing door is shut while stationary. When the motor kicks on the G-force
opens both ends to spread feed. When the motor stops the doors close and stops
feed from flowing out of the funnel, and keeps the critters from being able
to get their paws between the cone and the slinger. Not recommended for a 6
volt system. This bad boy needs 12 volts to function properly. Fits 1/4" shaft
motors. Motor shaft Hubs on the Swing Door Slinger are SS304 (stainless steel) to prevent corrosion.
|If you're having trouble getting your spinner plate off of the motor shaft, I suggest using a punch style blunt tipped object that is slightly smaller than the shaft and a hammer to drive the motor shaft out of the spinner hub. Remove the nuts holding the motor to the top of the control box. It is tough to get a seized spinner hub off the motor shaft from time to time when it gets corroded. You might have to use some force but it should work and come free and fall into the bottom of the box. Putting a piece of wood or something inside the box to support the top will also help to keep the box from flexing, freeing the motor faster.|
The "No Blow" mounts to any 1/8" motor shaft on the market. The cup design allows
you to avoid feed loss due to wind blowing on other flat plate designs. Four
steel paddles help propel feed away from the slinger on contact.
8 drain holes in the bottom make our replacement spinner the BEST in the business!
$5.99 IN STOCK! ITEM # 1.21