1,200# Automatic Feeder w/ Large 12v System
The 1200lb. capacity hopper is 3/8" thick wall of HDPE UV Protected plastic that will not rot, rust or leak!
Our hopper has built in channels that the legs fit into. Adjustable hardware components allow
you to adjust the height for conversion from automatic timer feeding in the fall, to gravity
feeding protein through the summer months. Our spin cast feeder is built to be rock solid, water proof,
and resist condensation.
Our double walled hatch LID tops this unit off in style,
and function. Built oversized, this lid allows the hopper system to breath, thus eliminating condensation while achieving ambient
temperature faster than
Steel or Fiberglass feeders. The Non-Typical hopper only
weighs 60 lbs. so moving the feeder even into remote locations is a snap! You don't have to have
a truck to move it. Your 4-wheeler and any small trailer will do. We do suggest that you
get a buddy to help you raise it and lower the system.
Holds approximately 1200#'s of corn.
Set the 1200 series Auto Unit to feed 5 seconds , twice a
day, and it will feed for 6 months without refilling the hopper !!!
Convert from spin feeder to protein feeder in minutes!
VERY IMPORTANT: If converting a 1200# Protein Feeder to a 1200# Automatic Spin Cast Feeder you will need the stop bracket plate.
Download Instructions Here
| Always charge your batteries before deploying them into the field. The new batteries are not always fully charged. |
|
Boss Buck recommends using the Feeder Filling Station® to fill your Non-Typical Spin Cast Feeder. Portable, safe, fast and affordable, the Feeder Filling Station® is a must for making short work of filling up feeders! We timed it at 17 minutes to fill the entire Non-Typical Spin Cast Feeder with corn. That's 24 bags! Now that's fast! It only cost $239.00 too! That's the best part.
The Non-Typical foot design is completely unique! The feet are designed to except a T-Post through the center of the foot. The feet are large 7" square steel plates. Each foot has a large nut welded to it and a ½" bolt that when tightened secures the feeder to the T-Post. This will not only protect the feeder but keep it level and immobile.
The buyer or agent of the buyer is responsible for inspecting all merchandise prior to loading. It is also the responsibility of the buyer or agent of the buyer to personally tie down/fasten/secure the merchandise properly. Employees of Boss Buck Inc. are not allowed to or assist in tying down/fastening/securing of the merchandise. Boss Buck Inc. reserves the right to refuse loading any merchandise in or on any vehicle it deems inappropriate for a given load and thereby a safety hazard. Once the merchandise is picked up and removed from our premises, Boss Buck Inc. is not liable to lost or damaged merchandise due to improper or failure to tie down/fasten/secure the merchandise.
Generally a second spin cast feeder ships for little or no extra cost.